KEY2U, Key Fob, Keyless Entry Remote Control Replacement for Ford Lincoln Mercury OEM Compatible, 4 Button (Pack of 2)

Pair of replacement keyless entry remote transmitter with battery and electronics installed.

Work On:

This part is Compatible with the following vehicles and part numbers:
2001-2012 Ford Escape
2007-2009 Ford Crown Victoria
1998-2003 Ford Escort
1998-2012 Ford Expedition
1998-2013 Ford Explorer
2001-2010 Ford Explorer Sport Trac
2005-2007 Ford Five Hundred
2000-2012 Ford Focus
2006-2012 Ford Fusion
1999-2012 Ford Mustang
1999-2011 Ford Taurus
2002-2005 Ford Thunderbird
2003-2005 Lincoln Aviator
2000-2006 Lincoln LS (dealer program only)
2001-2012 Lincoln Navigator
1998-2009 Lincoln Town Car
1999-2002 Mercury Cougar
2007-2011 Mercury Grand Marquis
2005-2011 Mercury Mariner
2005-2007 Mercury Montego
1999-2005 Mercury Sable
1999 Mercury Tracer

8L3Z15K601B, 8L-3Z-15K-601B, CWTWB1U212, CWTWB1U331, GQ43VT11T, CWTWB1U345, 1788A-FWB1U345, 1470102326, 1788104575

How to Program your Fob Replacement:

Option 1:

1.Close all doors, then open driver’s door and press the Unlock button on driver’s door while it is open and insert key into the ignition.

2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)

3. Within 10 seconds press any button on the first remote transmitter to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.

4. Within 10 seconds, press any button on the second remote transmitter. Door locks will cycle again to confirm programming. Repeat step 4 for all other remotes.

5. Turn ignition to OFF. Locks will again cycle to indicate the end of programming mode.

*If this does not work try the procedure with the door closed.

Option B:

1. Close all doors

2. Turn the ignition from OFF to RUN 4 times within 3 seconds.

3. Turn the ignition OFF. The system will chime to confirm programming mode.

4. Within 10 seconds, press and hold any button on the first remote transmitter. The system will chime once to confirm programming.

5. Within 10 seconds, press and hold any button on the second remote transmitter. The system will chime once to confirm programming.

6. Turn ignition to RUN to exit programming mode.

Please note: All steps should be performed in rapid succession. If you do not hear the initial chime or door lock cycle, this means the vehicle never entered programming mode. You should remove the key from ignition, open and close the door and start over.