key2u, 2pcs. Ford Lincoln Mercury Key Fob, Keyless Entry Remote 3 Button OEM Compatible
This is a Brand New Replacement Remote Fob Transmitter, Including battery. 100% new, never used.
Pair of 3 Button Remote Transmitter Key Fob Ford Lincoln Mercury OEM Compatible.
Compatible with:
2003-2013 Ford E-Series E150 E250 E350
2003-2013 Ford Econoline
2007-2015 Ford Edge
2001-2013 Ford Escape
1999-2003 Ford Escort
2000-2005 Ford Excursion
1998-2011 Ford Expedition
1998-2015 Ford Explorer
2001-2010 Ford Explorer Sport Trac
1998-2016 Ford F-Series F150 F250 F350
2004-2007 Ford Freestar
2005-2007 Ford Freestyle
1998-2011 Ford Ranger
1998-2003 Ford Windstar
2006-2008 Lincoln Mark LT
1998-2002 Lincoln Navigator
1999-2009 Mazda B-Series Pickup
2001-2011 Mazda Tribute
2005-2011 Mercury Mariner
1998-2010 Mercury Mountaineer
2000-2002 Mercury Cougar
2009-2016 Ford Flex
2006-2012 Ford Fusion
2008-2009 Ford Taurus X
How to Program your key2u Key Fob Remote Transmitter.
Option A:
1.Close all doors, then open driver’s door and press the Unlock button on driver’s door while it is open and insert key into the ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)
3. Within 10 seconds press any button on the first remote transmitter to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4. Within 10 seconds, press any button on the second remote transmitter. Door locks will cycle again to confirm programming. Repeat step 4 for all other remotes.
5. Turn ignition to OFF. Locks will again cycle to indicate the end of programming mode.
*If this does not work try the procedure with the door closed.
Option B:
1. Close all doors
2. Turn the ignition from OFF to RUN 4 times within 3 seconds.
3. Turn the ignition OFF. The system will chime to confirm programming mode.
4. Within 10 seconds, press and hold any button on the first remote transmitter. The system will chime once to confirm programming.
5. Within 10 seconds, press and hold any button on the second remote transmitter. The system will chime once to confirm programming.
6. Turn ignition to RUN to exit programming mode.
Please note: All steps should be performed in rapid succession. If you do not hear the initial chime or door lock cycle, this means the vehicle never entered programming mode. You should remove the key from ignition, open and close the door and start over.
Tabs Content